MIG Welder Buying Guide: Pulse vs Double Pulse MIG Explained
Standard MIG vs pulse vs double pulse
- Standard MIG: a constant arc. Great for mild steel fabrication, repairs and general work.
- Pulse MIG: the machine switches between a high and low current many times a second. That gives less heat input, less spatter and a neater weld, which helps a lot on thin material, stainless and aluminium.
- Double pulse MIG: adds a second, slower pulse on top. This gives more heat control and can produce the "stacked dimes" look many people associate with TIG.
Is double pulse MIG worth it for aluminium?
If you MIG weld aluminium regularly, pulse and double pulse make it much more manageable. You get better heat control on thin sections and a more consistent appearance. If you mostly weld mild steel, standard MIG or single pulse will cover most jobs.
Can pulse MIG give a TIG like finish on aluminium?
Double pulse can get close in appearance and is much faster than TIG. For show quality welds on thin or critical parts, TIG still gives the most control. Many shops use pulse MIG for production and TIG for the jobs that need it.
To MIG weld aluminium you'll also need the correct setup: a spool gun or push pull gun (such as the Parker DSP 360 Spool Gun), the right drive rolls, liner, contact tip, filler wire and shielding gas.
MIG for thin sheet through to structural steel
If your work ranges from thin sheet to heavier structural steel, you'll want enough output plus good low end control. Synergic controls, where you set the material and thickness and the machine suggests the settings, make switching between jobs quick.
Which Everlast MIG suits your workshop?
- Cyclone 140E: compact and simple, for home workshops and lighter fabrication.
- Cyclonei 212: portable, dual voltage MIG/stick with up to 230 amps of MIG output and PowerSET synergic controls. We even built a trailer chassis using only the Cyclone 212i.
- Cyclone 263DPI: MIG, single pulse MIG, Lift TIG and stick. A great one machine option for busy fabrication and automotive shops.
- Cyclone 273DPI: single and double pulse MIG plus flux core, DC TIG and stick, with a 4.3" colour display.
- Cyclone 313DPI: up to 315A, a four roll wire feeder and 30 memory channels.
- Cyclone 373DPI: a water cooled single/double pulse package with separate wire feeder, for production work.
- Cyclone 503DPI and PowerMTS 400: heavy duty industrial machines for high output fabrication.
For a small fabrication workshop, we’d suggest the Cyclonei 212 for general steel fabrication, repairs and portable work. If you regularly weld aluminium or stainless and want pulse capability, consider the Cyclone 263DPI with single pulse, or the Cyclone 273DPI with single and double pulse, depending on your requirements and budget.
Multiprocess or Separate Machines?
A multiprocess machine suits workshops with limited space that mainly MIG weld and occasionally need stick or DC TIG.
Separate MIG and AC/DC TIG machines are the better choice when both processes are used regularly, two people need to weld simultaneously, or aluminium TIG is required. The DC TIG function on the MIG models listed doesn’t replace an AC/DC TIG machine for conventional aluminium TIG welding.
Want advice for your exact jobs? Call (03) 8593 7509 or compare models on Compare the Range.
